
Cables
A permanent power supply is needed during the measurements.
The communication between sensor and PC has to be permanently connected during the measurements.
6.1 Total station cables
439 038 GEV71, 4m car battery cable, connects TPS or GPS receiver (Lemo-1, 5 pin, female) to
12V car battery. (Note, for TPS e.g. the additional cable 734 698 is required.)
734 698 GEV187, Y-cable, connects TPS to PC (9-pin RS232 serial) and external battery, 2.0m.
759 257 GEV220, Y-cable, connects TM30/TS30 to PC (9-pin RS232 serial) and external battery,
2.0m.
6.2 GPS1200 / GMX902 cables
To connect two independent power supplies
733 298 GEV172, 2.8m Y-cable, connects GPS Receiver with two external power supplies.
To connect battery, car battery or alternate power supply
439 038 GEV71, 4m car battery cable, connects TPS or GPS receiver (Lemo-1, 5 pin, female) to
12V car battery. (Note, for GPS e.g. the 560 130 or 636 972 is required.)
560 130 1.8m cable, connects GEB171 external battery to GPS1200 receiver. Lemo-1, 5 pin, male
to Lemo-1, 5 pin, male.
636 972 0.5m cable, connects GEB171 external battery to GPS1200 receiver. Lemo-1, 5 pin, male
to Lemo-1, 5 pin, male.
722 411 Cable with protection fuse to connect 12V power supply to GPS receiver.
To transfer data between sensor and spider
733 280 GEV160, 2.8m Data transfer cable. Connects GPS1200 receiver Ports 1, 2 and 3, RX1220
or GMX902 to PC for data transfer, firmware upload etc. Lemo 8 to 9 pin RS232 female
serial connector.
563 809 GEV113, 2.8m Modem cable. Connects GPS receiver Ports 1, 2 and 3 to modem. Lemo 8
Pin to 9 Pin RS232 male serial connector.
733 290 GEV168, 5.0m cable, connecting GPS Receiver with Ethernet LAN / RJ45
6.3 GMX901 cables
750 073 GEV212, Interface Cable, 5m, GMX901 to unterminated, connects GMX901 to a custom
installation.
743 389 GEV197, Y-Cable, 2.8m, GMX901 to RS232 and external Leica power supply.
49
Komentáře k této Příručce